Preparation: Ensure safe and smooth operation

Before changing the water of the ika calorimeter, make good preparations. Turn off the power of the calorimeter to prevent the risk of electric shock during operation. At the same time, prepare clean distilled or deionized water to avoid impurities in the water affecting the performance of the instrument. In addition, prepare a clean and soft rag for wiping the surface of the instrument that may appear water stains.

Drainage steps: completely drain the old water

Locate the tank drain port of the ika calorimeter, usually located at the bottom or side of the instrument. Connect the drain pipe to the drain port and place the other end in a suitable drain container. Open the drain valve and let the old water in the tank drain slowly. During the drainage process, pay attention to observe the water flow to ensure that the old water is completely emptied. If the drainage speed is slow, shake the instrument gently to help the water flow drain smoothly. After draining the water, close the drain valve.

Water addition steps: accurately inject new water

Slowly inject the prepared clean water source into the water tank through the water filling port of the calorimeter. When adding water, pay attention to observe the water level scale line on the water tank, and add it strictly according to the water level required by the instrument manual to avoid adding too much or too little water. The water addition speed should not be too fast to prevent water overflow. After adding water, carefully check whether the water filling port is well sealed to prevent water leakage.

Follow-up inspection: ensure that the instrument is normal

After completing the water change, check again whether the connection part of the instrument is firm and whether there is any water leakage. Wipe the surface of the instrument with a clean rag to keep the instrument clean and tidy. Then, turn on the power supply, turn on the calorimeter, observe the running status of the instrument, and check whether the parameters are normal. If any abnormality is found, the power supply should be turned off immediately, and the water change steps should be re-checked to troubleshoot the problem.

Mastering the water change method of the ika calorimeter can not only ensure the normal operation of the instrument, but also prolong its service life. By following the above steps, you can easily complete the water change work and let the calorimeter serve you continuously and stably.