As an accurate detection equipment, the cleanliness of the calorimeter tank is directly related to the stability of the equipment operation and the accuracy of the test results. Regular cleaning of the calorimeter tank is the key to ensuring the efficient operation of the equipment. Here is a simple and practical cleaning process for you.

Preparation before cleaning

Before cleaning, be sure to turn off the power of the calorimeter and unplug it to prevent the risk of electric shock. Prepare cleaning tools such as clean soft cloth, brush, special detergent and distilled water. At the same time, prepare a container for receiving residual water in the tank.

Empty the water tank

Find the drain port of the calorimeter water tank, place the container under the drain port, slowly open the drain valve, and let all the water in the water tank drain. If the drain port is blocked with impurities, you can use a brush to gently dredge it to ensure smooth drainage.

Clean the inside of the water tank

After the remaining water in the water tank is drained, dip a soft cloth in an appropriate amount of special detergent, and carefully wipe the inner wall of the water tank, focusing on cleaning the area where scale and dirt gather. For stubborn stains, you can appropriately increase the amount of detergent and gently brush with a brush, but be careful to avoid scratching the inner wall of the water tank. After wiping, rinse the water tank with water until no detergent remains.

descaling treatment

If there is a lot of scale in the water tank, a descaling agent can be used for advanced treatment. According to the proportion of the descaling agent instructions, mix the descaling agent with water, pour it into the water tank, and soak it for a period of time. After the soaking is completed, rinse the water tank with water again to ensure thorough descaling.

External cleaning and inspection

In addition to the inside of the water tank, external cleaning is equally important. Wipe the outside of the calorimeter water tank with a clean soft cloth to remove dust and stains. After cleaning, check whether the various components of the water tank are in good condition, such as whether the sealing ring is aging, whether the drain pipe is unobstructed, etc. If any problems are found, replace or repair it in time.

Rewatering and debugging

Finally, distilled water is injected into the water tank until the specified water level is reached. Turn on the power supply, turn on the calorimeter, and check whether the equipment is running normally and whether the parameters are stable. If everything is normal, the cleaning work is successfully completed.

Regularly cleaning the calorimeter water tank according to the above steps can effectively prolong the service life of the equipment and ensure the accuracy and reliability of the test results.